Raytrace Antialiaser Dialog: Fast Adaptive Antialiaser
 
 
 
Bottom of the Page

Rendering menu Raytracer Settings Raytracer Global Parameters dialog Global Ray Antialiaser group Turn on global ray antialiasing. Choose Fast Adaptive Antialiaser from the drop-down list. ... button

Material Editor Material/Map Browser Raytrace material Raytracer Controls rollout Raytraced Reflection and Refraction Antialiaser group (enabled only if antialiasing is globally enabled) Choose Fast Adaptive Antialiaser from the drop-down list. ... button

Material Editor Material/Map Browser Raytrace map Raytracer Parameters rollout Raytraced Reflection and Refraction Antialiaser group (enabled only if antialiasing is globally enabled) Choose Fast Adaptive Antialiaser from the drop-down list. ... button

The Fast Adaptive Antialiaser dialog changes settings for the Raytrace material and maps Fast Adaptive antialiaser. You can use this dialog either globally, from the Raytracer Global Parameters rollout, or locally, from the Raytracer Controls rollout. When you locally change settings for an antialiaser, you don't affect the global settings for that antialiaser.

Interface

Blur / Defocus (Distance Blur) group

Blur Offset is similar to blur offset for Bitmaps, while defocus is based on distance.

Blur Offset

Affects the sharpness or blurriness of the reflections or refractions without regard to distance. You can use Blur Offset to soften or defocus the details of a reflection or refraction. The value is specified in pixels. Default=0.0.

TipThe default Blur Offset setting usually produces good results. If you see aliasing in reflections or refractions, increase its value in increments of 0.5 until the aliasing goes away.

See Blur/Blur Offset.

Blur Aspect

This is an aspect ratio that changes the shape of the blur. Usually you will not need to change it. Default=1.0.

TipIf you see aliasing that occurs mostly along horizontal lines, try increasing Blur Aspect to 1.5. This changes the shape of the blurred effect. The reverse is also true. If aliasing occurs mostly along vertical lines, try decreasing Blur Aspect to 0.5.
Defocusing

Defocusing is a blur based on distance. With Defocus, objects near the surface are not blurred, but objects farther away are blurred. The rays cast are spread as they leave the Raytrace material object's surface. Default=0.0.

TipIncreasing the value of Defocusing can give a good distance blurring effect. Small adjustments are usually adequate. Try starting with a value less than 0.1, and increase or decrease it as necessary. Also try adjusting Reflect Falloff in Raytrace material or Attenuation in Raytrace map to get the best distance blurring effect.
Defocus Aspect

This is an aspect ratio that changes the shape of the defocusing. Usually you will not need to change it. Default=1.0.