Extrude Vertices/Edges (Polymesh)
 
 
 
Bottom of the Page

Select an Edit Poly or editable poly object. Modify panel Vertex/Edge/Border sub-object level Edit Vertices/Edges/Borders rollout Extrude (Settings)

Select an Edit Poly or editable poly object. Vertex/Edge/Border sub-object level Quad menu Tools 2 quadrant Extrude (Settings)

Select an Edit Poly or editable poly object. Modeling ribbon Graphite Modeling Tools tab Polygon Modeling panel (Vertex) or (Edge) sub-object level Vertices or Edges panel Shift+click (Extrude) or choose Extrude Settings from the drop-down list.

Use these settings for extruding vertices, edges, and borders in Interactive Manipulation mode.

NoteAt the Border sub-object level, this caddy is named Extrude Edges.

Interface

For details on using the caddy controls, see Editable Poly Settings.

Extrusion Height

Specifies the amount of the extrusion in scene units.

You can extrude sub-objects outward or inward, depending on whether the value is positive or negative.

Extrusion Base Width

Specifies the size of the extrusion base in scene units.

You can set this as high as you want, but the actual size cannot extend beyond the vertices adjacent to the extruded sub-object(s).

_____

OK

Applies the settings to the current selection and closes the caddy.

Apply and Continue

Applies the settings to the current selection, retaining them for the preview if you then change the selection.

Cancel

Closes the caddy without applying the settings to the current selection. Does not reverse previous uses of Apply.