Topology Overlay Analysis - Output Attributes dialog box
 
 
 
NoteThis functionality applies only to drawing objects.

Use this dialog box to select the data to attach to the result topology when performing a topology overlay.

To find sliver polygons when overlaying two topologies

Click Analyze tabDrawing Object panelObject Overlay. At the Command prompt, enter mapanoverlay.

The selected fields and columns are incorporated into a new object data table that is attached to the result topology.

Source Attributes for New Topology

To copy data from the source topology to the result topology, click Expression Builder. In the Expression Chooser dialog box, select the object data fields or external database columns to copy.

Overlay Attributes for New Topology

To copy data from the overlay topology to the result topology, click Expression Builder. In the Expression Chooser dialog box, select the object data fields or external database columns to copy.

Expression Builder s

Click to display the Expression Chooser dialog box, where you can select the data to include in the resulting topology.

New Object Data Table Name

Enter a name for the object data table that will store the data in the new topology. The Table Name should be a new name.

New Table Description

Enter a description for the new object data table in the resulting topology.

Load

Use settings that you previously saved.

Save

Save the current settings so you can use them again.

Cancel

Close the dialog box without performing the topology overlay.

Back

Display the previous dialog box.

Next

Click to display the next dialog box. Next is disabled if your source topology is a node topology.

Finish

Perform the topology overlay using the current settings. The Finish is available after you select the overlay topology and enter a valid topology name for the resulting topology.