Use the Interactive option
in the Select Actions Page if you
want to review the list of errors detected by the Drawing
Cleanup command, place error markers showing their location
in the map, and zoom to and highlight errors to better examine them.
Correct errors one at a time or correct all the errors detected
for a selected cleanup action as a single action.
You can configure
error markers on the Drawing Cleanup
- Error Markers dialog box. You can also indicate whether
to maintain markers both from earlier cleanup operations and after
the current cleanup operation.
Review, mark, and correct
- All cleanup actions are represented in
the Drawing Cleanup Errors dialog box,
except for Simplify Objects, which is
not an interactive operation.
- If you are cleaning up short objects, AutoCAD Map 3D divides
the detected errors into three groups: Short Degenerate Objects, Short
Line Objects, and Short Polyline Objects so
you can evaluate and correct these types of errors separately. If
you are cleaning up zero length objects, AutoCAD Map 3D divides the
errors into two groups: Zero Length Line Objects and Zero
Length Polyline Objects.
- When you fix an error or group of errors,
it may affect the errors further down the list. For example, if
you break two crossing objects and create four new, shorter objects,
the new objects may be shorter than the tolerance specified for Erase
Short Objects tolerance. Drawing Cleanup would detect
these as new, additional errors and add them to the list.
- Objects are not updated visually until
you close the dialog box. When you review the new errors, objects
will not appear in their corrected state.