Topology Dissolve - Create New Centroids and Nodes dialog box
 
 
 
NoteThis functionality applies only to drawing objects.

Use this dialog box to specify the block to use to create nodes and centroids in the resulting dissolve topology.

To dissolve a composite topology

Click Analyze tabDrawing Object panelDissolve. At the Command prompt, enter mapandissolve.

Point Object for Centroid Creation

Specify the block used to represent centroids.

  • To select from a list of block definitions in the drawing set, click the down arrow.
  • To create centroids from a block saved as a DWG file, click Browse. Select the file to use.
  • To create centroids a point, leave the box blank or enter ACAD_POINT.
Point Object for Node Creation

Specify the block used to represent nodes.

  • To select from a list of block definitions in the drawing set, click the down arrow.
  • To create nodes from a block saved as a DWG file, click Browse. Select the file to use.
  • To create nodes as a point, leave the box blank or enter ACAD_POINT.
Cancel

Close the dialog box without performing the dissolve.

Back

Display the previous dialog box.

Next

Disabled because this is the last dialog box in the list.

Finish

Dissolves the topology using the current settings. The Finish is available after you specify the dissolve parameter and enter a valid topology name.