Load Topology From Source Drawing dialog box
 
 
 
NoteThis functionality applies only to drawing objects.

Use this dialog to set options when loading a topology from a source drawing.

To load a topology

Click Analyze tabDrawing Object panelLoad Topology. At the Command prompt, enter maptopoload.

Topology Objects

Create Topology Objects When Loaded

If the selected topology is from a source drawing, select this check box to copy the topology objects into the current drawing as the topology is loaded. If this option is not selected, the objects are loaded but are not copied into the current drawing.

Select Topology Objects For Save Back

Select this option to add objects in the current drawing to the save back set if they are referenced by the selected topology. This means that the objects will be saved back to their source drawings and replace the original objects.

Topology Verification

Audit Geometry of Topology Objects

Select this option to verify that objects for the selected topology are geometrically correct. Any objects that are not correct are highlighted.