MAPNODINS (Insert Topology Node command)
 
 
 
NoteThis functionality applies only to drawing objects.
Warning This command will not be supported in future releases. This is the old command for inserting a node in a topology. The new command is MAPIN.

Use this command to insert a node on an existing link while maintaining the integrity of the topology information.

To create a node on an existing link

MAPIN

Respond to the prompts:

Enter topology name (? for list) <toponame>:

Enter the name of the topology to modify. To display a list of all loaded topologies, enter ?.

Specify insertion point:

Enter the coordinates of a point or select a point on the screen. If any block definitions exist in the drawing, you are prompted for a block to reference. The default block name is the last block name referenced in the drawing.

To add a node at the end of a dangling link, or to add a node not on a link, use the MAPNODADD (Add Topology Node command) command.