Solving Problems When Saving Back to Attached Drawings
Concept Procedure Quick Reference
 
 
 

To redefine block definitions on save back

  1. Click Map Setup tabMap panelangle-arrow. At the Command prompt, enter mapoptions.
  2. In the AutoCAD Map Options dialog box, click the Save Back tab.
  3. Under Save Back To Source Drawings, select Redefine Block Definitions On Save Back.
  4. Click OK.

To save back individual block components

  1. Click Home tabData panel Add To Save Set. At the Command prompt, enter adeselobjs.
  2. Select all the block components.
  3. Press Enter.

To check that the hatch pattern is in the save set

  1. Click Home tabData panel Show Objects In Save Set. At the Command prompt, enter adeshowobjs.
  2. If the hatch pattern is not highlighted, make sure that all boundary objects are added to the save set.