Extend Undershoots
Concept Procedure Quick Reference
 
 
 

To extend undershoots

  1. Click Tools tabMap Edit panelClean Up. At the Command prompt, enter mapclean.
  2. On the Select Actions page, in the Cleanup Actions list, click Extend Undershoots. Click Add.
  3. In the Select Actions list, click Extend Undershoots to display the cleanup parameters for this action.
  4. Under Cleanup Parameters, set Tolerance to a value slightly larger than the largest gap.

    You can enter a value into the Tolerance box or click Pick to go to the map and select two points that define the tolerance to use.

  5. To break target linear objects at the intersections during the Extend Undershoots operation, select Break Target.
  6. Continue specifying Drawing Cleanup settings.
Note Using the Extend Undershoots option on an arc whose endpoints are very close may result in the duplication or extension of the arc.