UNDO
 
 
 

Reverses the effect of commands.

 Toolbar: Standard 
 Command entry: undo

Enter the number of operations to undo or [ Auto/ Control/ BEgin/End/ Mark/Back]: Enter a positive number, enter an option, or press Enter to undo a single operation

UNDO displays the command or system variable name at the Command prompt to indicate that you have stepped past the point where the command was used.

NoteUNDO has no effect on some commands and system variables, including those that open, close, or save a window or a drawing, display information, change the graphics display, regenerate the drawing, or export the drawing in a different format.

Number

Undoes the specified number of preceding operations. The effect is the same as entering u multiple times.

Auto

Groups the actions of a single command, making them reversible by a single U command. When the Auto option is on, starting a command groups all actions until you exit that command. You can undo the group of actions as if it were one action.

UNDO Auto is not available if the Control option has turned off or limited the UNDO feature.

Enter UNDO Auto mode [ON/OFF] <current>: Enter on or off, or press Enter

Control

Limits or turns off UNDO.

Enter an UNDO control option [All/None/One/Combine/Layer] <All>: Enter an option or press Enter

All

Turns on the full UNDO command.

None

Turns off the U and UNDO commands and discards any UNDO command information saved earlier in the editing session. The Undo button on the Standard toolbar is unavailable.

The Auto, Begin, and Mark options are not available when None or One is in effect. If you attempt to use UNDO while it is turned off, the following prompt is displayed:

Enter an UNDO control option [All/None/One/Combine/Layer] <All>:

One

Limits UNDO to a single operation.

The Auto, Begin, and Mark options are not available when None or One is in effect. The main prompt for the UNDO command changes to show that only a Control option or a single step of the UNDO command is available when the One option is in effect.

Enter and option [Control] <1>:

If you enter c, the previous prompt is displayed:

Enter an UNDO control option [All/None/One/Combine/Layer] <All>:

Combine

Controls whether multiple, consecutive zoom and pan commands are combined as a single operation for undo and redo operations.

Combine zoom and pan operations? [Yes/No] <Yes>: Enter y or n or press Enter

NotePan and zoom commands that are started from the menu are not combined, and always remain separate actions.
Layer

Controls whether the layer dialog operations are combined as a single undo operation.

Combine layer dialog operations? [Yes/No] <Yes>: Enter y or n or press Enter

Begin, End

Groups a sequence of actions into a set. After you enter the Begin option, all subsequent actions become part of this set until you use the End option. Entering undo begin while a group is already active ends the current set and begins a new one. UNDO and U treat grouped actions as a single action.

If you enter undo begin without undo end, using the Number option undoes the specified number of commands but does not back up past the begin point. If you want to go back to before the begin point, you must use the End option, even if the set is empty. The same applies to the U command. A mark placed by the Mark option disappears inside an UNDO group.

Mark, Back

Mark places a mark in the undo information. Back undoes all the work done back to this mark. If you undo one operation at a time, you are informed when you reach the mark.

You can place as many marks as necessary. Back moves back one mark at a time, removing the mark. If no mark is found, Back displays the following prompt:

This will undo everything. OK? <Y>: Enter y or n or press Enter

Enter y to undo all commands entered in the current session. Enter n to ignore the Back option.

When you use the Number option to undo multiple actions, UNDO stops if it encounters a mark.