Dimension Jog
 
 
 

Jog lines can be added to linear dimensions. Jog lines are used to represent a dimension value that does not display the actual measurement. Typically, the actual measurement value of the dimension is smaller than the displayed value.

Show Me: Add a Jog to a Linear Dimension

The jog is made up of two parallel lines and a cross line that forms two 40-degree angles. The height of the jog is determined by the linear jog size value of the dimension style.

Once you add a jog to a linear dimension, you can position it by using grips. To reposition the jog, select the dimension and then select the grip. Move the grip to another point along the dimension line. You can also adjust the height of the jog symbol on a linear dimension on the Properties palette under Lines & Arrows.

To add a jog to a linear dimension
To add a jog to a linear dimension based on the midpoint of the selected dimension line
To reposition a jog using grips
To remove a jog
To modify the height of a jog using the Properties palette
Commands
System Variables
Utilities
Command Modifiers